Landrum 9.5" x 5.5" O.D. Elite Series Front Coil Springs

Landrum Elite Series coil springs for circle track racing were introduced after extensive research, development and engineering, the Elite Series coil springs, both front and rear applications, have been designed to exceed the high demands racers and crew chiefs expect. The Elite Series coil springs are made from chrome silicon high-tensile American made steel and are lightweight. They will give the most travel with no loss in spring height or rate. As always, Landrum Performance springs has the tightest tolerances in the industry—and you always get a dyno sheet to prove it! Don't settle for the anything less but the best when it comes to suspension performance. Choose the Landrum Elite Series coil springs!

Elite Series front coil spring features:

* Available in front or rear coil spring applications (specify when ordering)
* All front springs are closed and ground on one end to provide proper contact with the jack plate, not forged
* All rear springs are closed and ground on both ends which insures proper contact with the jack plate and spring seat
* The opposite end is either open or closed tangential to fit properly into the lower control arm
* Cold wound, not hot wound, so each coilover spring is properly heat-treated and stress-relieved to ensure sides of spring remain parallel during installation
* Powder-coated, not plated to protect the spring from hydrogen embrittlement, a corrosive breakdown of the springs surface which decreases the springs life
* Each spring is designed with the correct pitch and height ratio to ensure consistent rate throughout the entire cycle