MSDs Non-Magnetic Pick-Ups are engineered for extreme applications. In fact, this Pick-Up was designed and tested on 300+ mph top fuel dragsters! To live up to MSDs demanding expectations in these extreme applications, we took it upon ourselves to design and build the Pick-Ups in-house. This way we can control every aspect of their assembly and quality. Each Pick-Up is hand wound on a special bobbin and terminated to our tinned conductor, teflon jacketed wiring. These wires are also routed through a strain relief for protection. This assembly is then installed into the precision housing and is potted with a fracture resistant epoxy compound. To ensure that the windings are entirely encased in epoxy, the Pick-Ups undergo a vacuum procedure to remove any air inside the housing. All of these procedures are necessary to produce the strongest, most reliable non-magnetic Pick-Up available. MSD Non-Magnetic Pickup Assembly 8276 Large - 0.75 in. x 12 x 2.25 in.Designed And Built In-House 3/4 x 16 x 2.25Completely PottedStrain ReliefProprietary Bobbin And Winding DesignFor Use With MSD Flying Magnet CrankPit Stop USAoffers MSD Ignition Non-Magnetic Pickup Assembly 8276 at low everyday prices. Be sure to check out all of the products from MSD Ignition including MSD Ignition Parts and Accessories, MSD Ignition Parts and Accessoriess, MSD Crank Trigger Parts and Accessories, MSD Crank Trigger Replacement Pickups.