Motor Flush - ?15 fl.oz Motor Flush thoroughly cleans and conditions the engines internal components to dissolve and eliminate sludge, gum and varnish buildup. Cleaner valves, rings and oil passages improve horsepower and fuel economy. The ER® Antifriction Metal Conditioner protects and conditions metal surfaces during the cleaning process resulting in reduced friction and increased performance. 15 oz. Bottle. Uses: Protect during cleaning process Remove varnish buildup Puts dirt particles back into suspension before draining oil Dissolve sludge & buildup Increase horsepower Improve fuel economy Directions: Use ER® Motor Flush immediately before changing the oil. Turn off engine and check oil level to ensure that oil is near full mark. Leave old oil filter in place during cleaning. Add one can of ER® Motor Flush to oil crankcase. Close oil filler top, start engine and run at normal idle for approximately 5 minutes. Do not drive vehicle or race engine until crankcase has been drained and fresh motor oil is added. Be sure to idle engine in open air or in area where fumes are vented to open air. Shut off engine and drain crankcase immediately. Remove oil filter. Replace drain plug. Install new oil filter and refill crankcase with fresh oil. Start engine and allow to idle 2 to 5 minutes to assure proper circulation of new oil to all vital parts. Do not spill ER® Motor Flush on car finish. Immediately wipe off if spilled. Pit Stop USA offers Energy Release® Motor Flush - ?15 fl. oz. P023 at low everyday prices. Be sure to check out all our products from Energy Release® including Energy Release® Engine Flush.